uname -a
FreeBSD 8.0-BETA1 FreeBSD 8.0-BETA1 #0: Thu Jul 9 12:15:09 CEST 2009 root@master:/usr/obj/nanobsd.node_ap_64M/usr/src/sys/KERNEL i386
ifconfig
ifconfig wlan0 up ifconfig sis0 up ifconfig wlan create wlanmode hostap wlandev ath0 ifconfig wlan0 ssid openping channel 9 ifconfig bridge0 create ifconfig bridge0 addm sis0 addm wlan0 up
dmesg
Copyright (c) 1992-2009 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 8.0-BETA1 #0: Thu Jul 9 12:15:09 CEST 2009
root@master:/usr/obj/nanobsd.node_ap_64M/usr/src/sys/KERNEL
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Geode(TM) Integrated Processor by National Semi (266.66-MHz 586-class CPU)
Origin = "Geode by NSC" Id = 0x540 Stepping = 0
Features=0x808131<FPU,TSC,MSR,CX8,CMOV,MMX>
real memory = 134217728 (128 MB)
avail memory = 116731904 (111 MB)
kbd1 at kbdmux0
ACPI Error: A valid RSDP was not found 20090521 tbxfroot-309
ACPI: Table initialisation failed: AE_NOT_FOUND
ACPI: Try disabling either ACPI or apic support.
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
sis0: <NatSemi DP8381[56] 10/100BaseTX> port 0xe100-0xe1ff mem 0xa0000000-0xa0000fff irq 10 at device 6.0 on pci0
sis0: Silicon Revision: DP83816A
miibus0: <MII bus> on sis0
nsphyter0: <DP83815 10/100 media interface> PHY 0 on miibus0
nsphyter0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
sis0: Ethernet address: 00:00:24:c3:e6:30
sis0: [ITHREAD]
ath0: <Atheros 5212> mem 0xa0010000-0xa001ffff irq 11 at device 14.0 on pci0
ath0: [ITHREAD]
ath0: AR5212 mac 5.9 RF5112 phy 4.3
wi0: <Intersil Prism2.5> mem 0xa0020000-0xa0020fff irq 5 at device 15.0 on pci0
wi0: [ITHREAD]
isab0: <PCI-ISA bridge> port 0x6100-0x613f,0x6200-0x623f at device 18.0 on pci0
isa0: <ISA bus> on isab0
pci0: <bridge> at device 18.1 (no driver attached)
atapci0: <National Geode SC1100 ATA33 controller> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xe000-0xe00f at device 18.2 on pci0
ata0: <ATA channel 0> on atapci0
ata0: [ITHREAD]
ata1: <ATA channel 1> on atapci0
ata1: [ITHREAD]
pci0: <bridge> at device 18.5 (no driver attached)
ohci0: <OHCI (generic) USB controller> mem 0xa0021000-0xa0021fff irq 9 at device 19.0 on pci0
ohci0: [ITHREAD]
usbus0: <OHCI (generic) USB controller> on ohci0
cpu0 on motherboard
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xc8000-0xd0fff pnpid ORM0000 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
atkbd0: [ITHREAD]
psm0: unable to get the current command byte value.
atrtc0: <AT Real Time Clock> at port 0x70 irq 8 on isa0
ppc0: parallel port not found.
uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
uart0: [FILTER]
uart0: console (9600,n,8,1)
Timecounters tick every 1.000 msec
usbus0: 12Mbps Full Speed USB v1.0
ad0: 61MB <064MB ATA Flash Disk AD-A015B> at ata0-master PIO4
ugen0.1: <(0x0e11)> at usbus0
uhub0: <(0x0e11) OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0
Root mount waiting for: usbus0
uhub0: 3 ports with 3 removable, self powered
Trying to mount root from ufs:/dev/ad0s1a
wlan0: Ethernet address: 00:0b:6b:34:59:8a
bridge0: Ethernet address: 8a:ba:b1:19:02:83
sis0: promiscuous mode enabled
wlan0: promiscuous mode enabled
sis0: link state changed to UP
sis0: link state changed to DOWN
sis0: link state changed to UP
ath0: stuck beacon; resetting (bmiss count 4)
ath0: stuck beacon; resetting (bmiss count 4)
ath0: stuck beacon; resetting (bmiss count 4)
ath0: stuck beacon; resetting (bmiss count 4)
ath0: stuck beacon; resetting (bmiss count 4)
ath0: stuck beacon; resetting (bmiss count 4)
#
ps ax
PID TT STAT TIME COMMAND
0 ?? DLs 0:02.18 [kernel]
1 ?? ILs 0:00.12 /sbin/init --
2 ?? DL 0:00.59 [g_event]
3 ?? DL 0:00.71 [g_up]
4 ?? DL 0:00.81 [g_down]
5 ?? DL 0:00.00 [xpt_thrd]
6 ?? DL 0:00.00 [sctp_iterator]
7 ?? DL 0:00.01 [pagedaemon]
8 ?? DL 0:00.00 [vmdaemon]
9 ?? DL 0:00.00 [pagezero]
10 ?? DL 0:00.00 [audit]
11 ?? RL 7:21.24 [idle]
12 ?? WL 0:14.31 [intr]
13 ?? DL 0:00.79 [yarrow]
14 ?? DL 0:00.00 [usbus0]
15 ?? DL 0:00.00 [usbus0]
16 ?? DL 0:00.11 [usbus0]
17 ?? DL 0:00.00 [usbus0]
18 ?? DL 0:00.07 [bufdaemon]
19 ?? DL 0:00.14 [syncer]
20 ?? DL 0:00.06 [vnlru]
21 ?? DL 0:00.05 [softdepflush]
22 ?? DL 0:00.01 [flowcleaner]
40 ?? DL 0:00.39 [md0]
50 ?? DL 0:00.17 [md1]
569 ?? Is 0:00.15 /usr/sbin/syslogd -s
807 ?? Ss 0:00.08 /usr/sbin/cron -s
855 u0 Is 0:00.24 login [pam] (login)
862 u0 S 0:00.64 -csh (csh)
895 u0 R+ 0:00.05 ps ax
dbs.cfg
# box 11
{
sender
{
hostname=10.0.0.11;
hostname_cmd=10.11.0.11;
port=20011;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.111;
hostname_cmd=10.0.0.111;
port=20011;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box11;
send_times=500000;
protocol=UDP;
start_time=11.0;
end_time=40;
}
# box 12
{
sender
{
hostname=10.0.0.12;
hostname_cmd=10.11.0.12;
port=20012;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.112;
hostname_cmd=10.0.0.112;
port=20012;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box12;
send_times=500000;
protocol=UDP;
start_time=12.0;
end_time=40;
}
# box 13
{
sender
{
hostname=10.0.0.13;
hostname_cmd=10.11.0.13;
port=20013;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.113;
hostname_cmd=10.0.0.113;
port=20013;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box13;
send_times=500000;
protocol=UDP;
start_time=13.0;
end_time=40;
}
# box 14
{
sender
{
hostname=10.0.0.14;
hostname_cmd=10.11.0.14;
port=20014;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.114;
hostname_cmd=10.0.0.114;
port=20014;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box14;
send_times=500000;
protocol=UDP;
start_time=14.0;
end_time=40;
}
# box 15
{
sender
{
hostname=10.0.0.15;
hostname_cmd=10.11.0.15;
port=20015;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.115;
hostname_cmd=10.0.0.115;
port=20015;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box15;
send_times=500000;
protocol=UDP;
start_time=15.0;
end_time=40;
}
# box 16
{
sender
{
hostname=10.0.0.16;
hostname_cmd=10.11.0.16;
port=20016;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.116;
hostname_cmd=10.0.0.116;
port=20016;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box16;
send_times=500000;
protocol=UDP;
start_time=16.0;
end_time=40;
}
# box 17
{
sender
{
hostname=10.0.0.17;
hostname_cmd=10.11.0.17;
port=20017;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.117;
hostname_cmd=10.0.0.117;
port=20017;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box17;
send_times=500000;
protocol=UDP;
start_time=17.0;
end_time=40;
}
# box 18
{
sender
{
hostname=10.0.0.18;
hostname_cmd=10.11.0.18;
port=20018;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.118;
hostname_cmd=10.0.0.118;
port=20018;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box18;
send_times=500000;
protocol=UDP;
start_time=18.0;
end_time=40;
}
# box 19
{
sender
{
hostname=10.0.0.19;
hostname_cmd=10.11.0.19;
port=20019;
pattern{8192, 8192, 0.0, 0.0}
}
receiver
{
hostname=10.0.0.119;
hostname_cmd=10.0.0.119;
port=20019;
pattern{8192, 8192, 0.0, 0.0}
}
file = data/2009-07-09-19-54-48/box19;
send_times=500000;
protocol=UDP;
start_time=19.0;
end_time=40;
}
